EOL - J-600, J-300 and J-700 Can I use a J-8000 in an AX installation?


#1

YES! Below is the answer from the Niagara Community…

Question: How do I convert a Jace 8000 to run Ax?

Answer: Out-of-the-box a Jace 8000 can be connected to using N4 workbench only. In order to run Ax, use the Distribution File Installer to install a n4-to-ax conversion distribution file.

For complete information on the topic see:

docJace8000Startup.pdf in your N4 installation doc’s folder


#2

In addition to the information above, the latest release of Niagara, N4.6, cannot be installed on legacy JACE controllers (J-600, J-300, J-700, etc.)